What is the difference between LPTA and best value tradeoff?
Under lowest price technically acceptable (LPTA), the agency picks the lowest price among offers that meet every requirement, and doing better earns nothing. Under a tradeoff, the agency can pay more for a stronger offer, if it explains why the extra value is worth the price. Section M of the solicitation tells you which method applies.
Two businesses can write the same proposal for two different contracts and get opposite results. On one contract, a careful plan that goes beyond the minimum wins. On another, the same plan loses to a cheaper offer that just meets the requirements. The difference is how the agency said it would pick the winner. It’s written in the solicitation before you start, so read it first.
Same three offers, two different winners
| Price | Technical rating | Lowest price technically acceptable | Tradeoff | |
|---|---|---|---|---|
| Offer A | $410,000 | Acceptable | Wins | Maybe not |
| Offer B | $455,000 | Outstanding | No | Likely, if technical matters most |
| Offer C | $390,000 | Unacceptable | No | No |
Made-up example. A tradeoff winner depends on the weighting in Section M.
Sources: FAR 15.101-1, Tradeoff process · FAR 15.101-2, Lowest price technically acceptable source selection process. Checked Oct 28, 2026. The solicitation decides the details.
The two main ways agencies choose
| Lowest price technically acceptable | Tradeoff (best value) | |
|---|---|---|
| How the winner is picked | The lowest price among offers that pass every requirement | The offer that gives the most value for the price, which may not be the cheapest |
| Does going beyond the minimum help? | No. It’s pass or fail | Yes, if it’s a strength the agency values |
| Can the agency pay more? | No | Yes, but it must write down why the extra value is worth it |
| What usually decides it | Price | The weighting of factors in Section M |
| What you should do | Meet every requirement exactly, and price tight | Show strengths clearly, and price for the value you offer |
The Federal Acquisition Regulation (FAR) is the set of rules for how agencies buy. It describes both methods. In a tradeoff, the agency may choose an offer that isn’t the lowest priced. But the extra benefit must be worth the extra cost, and the reasons must be written in the contract file (FAR 15.101-1).
Under LPTA, “tradeoffs are not permitted.” Offers are checked to see if they pass, but they aren’t ranked (FAR 15.101-2).
Where to find the method in a solicitation
Look for these, in this order:
- Section M (evaluation factors for award) in a request for proposals (RFP). Look for a sentence that starts “Basis for award” or “Award will be made to.”
- The instructions or evaluation section of a request for quotes (RFQ). Shorter buys often put it in one paragraph near the end.
- Key phrases. “Lowest price technically acceptable” means LPTA. “Tradeoff,” or a list of factors with weights, means a tradeoff.
Be careful with “best value.” The FAR uses it for every method, so a solicitation can say “best value” and still award on the lowest acceptable price. Read the whole basis-for-award paragraph, not just the first words.
How to read the weighting words
In a tradeoff, the solicitation must list every factor that affects award and say how important each one is. It must also say how all the non-price factors together compare with price (FAR 15.304). You’ll usually see one of three phrases:
- “Significantly more important than price.” Quality matters most. A stronger plan can beat a lower price.
- “Approximately equal to price.” Quality and price count about the same.
- “Significantly less important than price.” Price matters most. This is close to LPTA, but strengths can still break a tie.
Factors are often listed “in descending order of importance.” Write them down in that order. That list is your outline.
What changes in your proposal
For LPTA:
- Make a checklist of every requirement, and answer each one plainly. One miss can make the whole offer unacceptable.
- Don’t spend pages on extras. The agency won’t give you credit for them.
- Price as low as you can while still covering your real costs. See how to build your hourly rate.
- If your past performance is judged unacceptable, a small business gets one more chance. The contracting officer must send the question to the Small Business Administration (SBA) first. That’s the Certificate of Competency process (FAR 15.101-2).
For a tradeoff:
- Answer every requirement, then show what makes your approach better. Name the strength and say why it helps the agency.
- Put your strongest points under the factor that matters most.
- You don’t have to be the cheapest. But a higher price has to be worth it to the evaluators, and they must be able to explain that in writing.
- For most negotiated buys above $350,000, the agency must also judge past performance, unless the contracting officer writes down why it isn’t needed (FAR 15.304). See past performance.
A worked example
| Price | Technical rating | Wins under LPTA? | Wins under a tradeoff? | |
|---|---|---|---|---|
| Offer A | $410,000 | Acceptable: meets every requirement | Yes. Lowest price that passes | Maybe not |
| Offer B | $455,000 | Outstanding: faster response times, a backup crew | No. Extra quality earns nothing | Likely, if technical is “significantly more important than price” |
| Offer C | $390,000 | Unacceptable: no staffing plan | No. It failed a requirement | No |
Offer C has the lowest price but loses either way, because it missed a requirement. Under LPTA, Offer A wins. Under a tradeoff that values technical work most, the agency could pick Offer B and pay $45,000 more. It would have to write down why the faster response and backup crew are worth it.
When agencies are told to avoid LPTA
The FAR says LPTA fits only when the agency can describe its minimum needs clearly and would get little or no value from a better offer (FAR 15.101-2). It also tells agencies to avoid LPTA, as much as they can, for work that depends mostly on knowledge and skill. Examples are IT services, cybersecurity and health care. The Defense Department has a similar set of limits of its own.
If a solicitation uses LPTA for complex work, you can ask about it during the question period. The agency decides, though. Many LPTA buys make sense, like routine supplies or simple services. See asking the contracting officer questions.
A third method in the FAR rewrite
The FAR overhaul’s Part 15 text adds a third method: award to the highest technically rated offer with a fair and reasonable price. It’s meant for work where the agency wants the best quality and will pay any fair price for it.
A proposed rule to make that text permanent was published on September 18, 2026. Comments closed on October 19. It isn’t final yet. Whatever the rules say, the solicitation tells you which method applies to that buy. See the proposed Part 15 changes.
Before you write
Basis for award check
0 of 7 checked
In FedPath, upload the solicitation to the compliance matrix generator. It lists each requirement it finds, with the section and page, and groups evaluation items so you can see what will be judged. Learn more about compliance matrices.
Key terms
- Basis for award
- The sentence in the solicitation that says how the winner will be chosen.
- Evaluation factors
- The things the agency will judge, such as technical approach, past performance and price.
- Lowest price technically acceptable
- The lowest-priced offer that meets every requirement wins. Extra quality doesn’t count.
- Tradeoff
- The agency weighs price against the other factors and may pick an offer that isn’t the cheapest.
- Technically acceptable
- Meets every minimum requirement in the solicitation. It’s a pass or fail.
- Section M
- The part of a solicitation that lists the evaluation factors and how they compare.
Do this in FedPath
Decide if the method suits you. Use the bid/no-bid tool to weigh whether you can win on price or on strengths before you start writing.
Free. FedPath is independent. It is not affiliated with, endorsed by, or part of the U.S. government, the Small Business Administration (SBA), SAM.gov, or any federal agency.
Common questions
Does the lowest price always win a federal contract?
No. Under LPTA, the lowest price among acceptable offers wins. Under a tradeoff, the agency can pay more for a better offer if it explains why.
What does “technically acceptable” mean?
That the offer meets every minimum requirement in the solicitation. It’s pass or fail, and doing more doesn’t raise your rating under LPTA.
Can a small business win a tradeoff without being the cheapest?
Yes. If the factors other than price matter more, a stronger plan or better past performance can beat a lower price. The evaluators must be able to explain why your offer is worth the difference.
What if the solicitation doesn’t say how factors are weighted?
The FAR requires a tradeoff solicitation to say how the factors compare. If you can’t find it, ask the contracting officer in writing before the question deadline.